What We Print

Every model in the Warden Works store is printed in-house in Canada using professional-grade MSLA resin printers. We use a custom Siraya Tech resin blend tuned for miniature detail — tight layer lines, sharp edges, and enough flexibility to survive tabletop handling without snapping.

The Resin

We print exclusively with Siraya Tech resins. Their professional blend gives us the right balance of detail resolution, impact resistance, and surface finish. No brittle hobby-grade resin — these models are built to be handled, painted, and played with.

Officially Licensed

Every designer in our catalog has granted a valid commercial print license for their files. We do not sell unlicensed prints. When you buy from Warden Works, the original creator gets compensated and you get a model you can display with confidence.

Quality Control

Each print is inspected before it ships. We check for layer failures, warping, support artifacts, and surface defects. If it does not meet our standard, it does not go in the box. We also wash and cure every model to spec so it arrives ready for primer.

Supports & Cleanup

Supports are removed by hand. We do our best to minimize scarring on visible surfaces, though some cleanup may be needed on complex geometries. All models ship with their supports off unless a part requires them for safe transit.

Ready to Paint

Warden Works models arrive washed, cured, and ready for primer. No soaking in IPA, no UV lamp required on your end — just prime and paint.

Questions?

If you have questions about a specific model, material, or print quality, reach out at orders@wardenworks.shop.